Level 6 · Land and bounce · weeks 16–20
Smith machine squat
A squat with the bar of a Smith machine across your upper back, its rails keeping the bar steady.
- 3 × 8
- A Smith machine
- Operated leg
General information, not medical advice. Follow your surgeon's and physio's plan. Read the disclaimer

Loading the 3D figure…
The knee-bend figure is this example's, not a target: early on you may bend less, later more.
Key positions


Follow along
The highlighted step is the one playing. Tap a step to see it.
How much
3 × 8
- Level 6 · Jumps + Gym A: 3 sets of 8 reps. Stop each set with 1-2 reps left. The first day, the bar alone. Count the bar and any plates; if the machine doesn't say what its bar weighs, ask at the gym. Use the same machine each time.
Your physio may set a different dose. Theirs wins.
Before you start
Level 6 usually starts around week 16 after surgery. Move on to it when you can tick off the checks of Level 5:
- No swelling, even after training
- The knee bends and straightens fully
- On the same machine, the heaviest weight each leg lifts 10 times with good form: the operated leg 80% or more of the other's
- Single-leg leg press: your body weight 8 times on the operated leg (a 45° press, counting the plates only)
- Single-leg bridge, heel on a step: 20 reps, one every 2 seconds at full height, within 5 of the other side
- Single-leg calf raise, knee straight, a fingertip for balance: 20 reps, one every 2 seconds, within 5 of the other side
- A single-leg squat to a knee-high box looks the same on both legs in a phone video: the phone at knee height, 2-3 m in front. The knee stays outside the big toe, the hip doesn't drop and the trunk doesn't lean
- Thigh strength, front and back, 80% or more of the other leg (measured by a physio)
After some surgeries done with the ACL, the app starts it later: Revision surgery, not before week 27.
This animation shows the exercise as the app describes it. It is general information, not medical advice. Follow your surgeon's and physiotherapist's instructions, and stop if the knee hurts.
If you had a meniscus repair or other surgery along with your ACL, your surgeon may limit how far you bend the knee or how much weight you put on the leg. Follow their limits.
After some surgeries done with the ACL, the app asks you to do it differently:
- Meniscus repaired (stitched), until week 18: After a meniscus repair, protocols usually stop loaded squats, presses and lunges at 90° of bend until about 4 months (week 18). Keep yours there.
- Meniscus root or complex repair, until week 18: Until about 4 months (week 18), protocols for a meniscus repair usually stop your loaded squats, presses and lunges at 90° of bend.
- Cartilage microfracture, until week 18: After microfracture, protocols usually stop your loaded squats, presses and lunges at 90° of bend until about 4 months (week 18).
On Level 6 the app adds a note after some surgeries:
- Patellar tendon graft: Front-of-knee pain is common with your patellar tendon graft. Protocols usually keep exercise pain below 5/10, easing range or load if it reaches 5.
- Quadriceps tendon graft: Front-of-knee pain is common with your quadriceps tendon graft. Protocols usually keep exercise pain below 5/10, easing range or load if it reaches 5.
- Donor graft (allograft): Donor (allo) grafts heal into the knee more slowly. Protocols usually progress your running and jumping more slowly, meeting every criterion before moving on.
From the steps:
- Set the safety stops just below your lowest point, start with the bar alone and add weight only while every rep stays smooth and pain-free; stop if the knee hurts
Next in the programme
All exercises by levelThe 3D figure
The figures are Sports_Male_04 from the Microsoft Rocketbox Avatar Library, MIT licence. The poses are computed in the browser from the steps. Microsoft Rocketbox
MIT License
MIT License
Copyright (c) 2020 Microsoft
Permission is hereby granted, free of charge, to any person obtaining a copy
of this software and associated documentation files (the "Software"), to deal
in the Software without restriction, including without limitation the rights
to use, copy, modify, merge, publish, distribute, sublicense, and/or sell
copies of the Software, and to permit persons to whom the Software is
furnished to do so, subject to the following conditions:
The above copyright notice and this permission notice shall be included in all
copies or substantial portions of the Software.
THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE
AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER
LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM,
OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE
SOFTWARE.
